You will need to copy the node address, which you will give to others to connect to the blockchain.
Blockchain connection: We will now connect to the blockchain elsewhere. On the second server we run the following command: multichaind chain1 [ip-address]:[port] node address We will be told that the blockchain has been successfully initialized, but we are not allowed to connect.
We will be shown another message containing the address of the wallet at the node. We copy the wallet address.
We return to the first server, where we add permissions for this address: multichain-cli LanțulMeu grant Câteva comenzi pentru modul interactiv Before we begin, we must first enter the interactive mode. On both servers: multichain-cli LanțulMeu The command to receive general information: getinfo to see all available commands: help to see all current bitcoin kali linux set listpermissions to create a new address in the wallet: getnewaddress to list all addresses in your wallet: getaddresses to get blockchain parameters based on the params.
On the first server, we get the address that has permission to toss coins: listpermissions issue We copy the address.
Now we will launch a coin on this node with units, each of them subdivided into parts, which we will send to each other: issue [here we write the address with permissions, copied earlier] MonedaMea 0. On the other server, check the block size: getinfo Congratulations! You have your own virtual currency.
If you have any questions, leave me a message in the comments section.